http://www.clubcivic.com/board/ Online Honda Civic community forum for owners of Honda Civic Coupe, Si, Ex, Dx, Lx, Cx, Vx, Hybrid, Del Sol, and CRX. Register for free to meet and share honda civic photos and information. en Thu, 20 Jun 2013 08:31:48 GMT vBulletin 60 http://www.clubcivic.com/board/images/misc/rss.jpg http://www.clubcivic.com/board/ http://www.clubcivic.com/board/showthread.php?t=222406&goto=newpost Thu, 20 Jun 2013 05:24:10 GMT As the post suggest, looking for 99 civic coupe mudguards front and rear. If your in the bay area even better, I can drive out to you or meet you halfway. thanks! As the post suggest, looking for 99 civic coupe mudguards front and rear. If your in the bay area even better, I can drive out to you or meet you halfway. thanks! ]]> Parts Wanted hondacivic1992 http://www.clubcivic.com/board/showthread.php?t=222406 http://www.clubcivic.com/board/showthread.php?t=222405&goto=newpost Thu, 20 Jun 2013 04:16:28 GMT Just acquired a 1990 dx hb, 127k miles, first old Honda. Owned a lot of cars from this era BMW 325ix ,Celica,,Infinity M vert,.& like the Civic a lot. I want to start.on suspension improvements, engine and then body & was wondering what recommendations I can get from people here, on improvements to the car .

Also my Civic runs great, but sometimes wont start, has spark , no fuel, happens intermittently and only with a warm engine, as in, just driven. any thoughts as to what to check first? ]]> New to the Site? jrio http://www.clubcivic.com/board/showthread.php?t=222405 http://www.clubcivic.com/board/showthread.php?t=222404&goto=newpost Thu, 20 Jun 2013 04:06:31 GMT DIY: 6th Gen *LX/DX/CX/HX* to* EX* Exhaust Conversion Information gathered by myself and from other sources. Compiled into one, easy to follow DIY. Please note though that this write-up is for replacing your ENTIRE exhaust system, from manifold to tailpipe. *_Items Needed:_* *EX... DIY: 6th Gen LX/DX/CX/HX to EX Exhaust Conversion
Information gathered by myself and from other sources. Compiled into one, easy to follow DIY. Please note though that this write-up is for replacing your ENTIRE exhaust system, from manifold to tailpipe.


Items Needed:
EX header/exhaust manifold
EX catalytic converter
O2 sensor extension wire harness/kit
EX aftermarket catback exhaust
Additional gaskets (exhaust manifold & cat to exhaust - if not provided with your NEW equipment)
Additional hardware (if not provided with your NEW equipment)


Introduction
Looking to install a newer, stronger, aftermarket header on your 6th Gen LX/DX/CX/HX Civic and wanting to open up your engine bay a bit more? Perhaps upgrade your entire exhaust system to something with a little more breathing room? In this DIY, I'll explain how to convert your exhaust to the EX system and the parts you will need.


LX/DX/CX/HX Exhaust Layout:

The headers that are made for 6th generation Civics are only made for EX models. The EX is considered to have a "normal" manifold as the catalytic converter is located under the body of the car, not inside the bay near the block. You'll notice with your LX/DX/CX/HX model Civic, the catalytic converter is located visibly from the bay, just after the start of your manifold.


EX Exhaust Layout:

Step 1: Install the NEW EX header.
Step 2: Install your NEW catalytic converter directly to the end of your newly installed header. You may be able to reuse your spring loaded bolts from your previous install. If not, stop by either (a) your local hardware store and pick-up some new 3" long 14mm grade 8 bolts with 1.5" washers and matching nuts. Be sure to reapply the spring from your previous setup. You can bolt it straight on without if you like but the springs are there to ease the tension from your header as your car moves/vibrates. (b) Stop by or order replacement spring-loaded bolts from a Honda retailer. (c) Hit-up your local junk-yard or pick-n-pull.
Step 3: Install your O2 sensor wire extension harness. The new primary is located in about the same area as your previous setup but your new secondary will be further below your car onto the BACK of your new catalytic converter.
Step 4: Install your NEW EX exhaust system onto the back of your newly installed catalytic converter.
Step 5: Enjoy! ]]> aeraiva http://www.clubcivic.com/board/showthread.php?t=222404 http://www.clubcivic.com/board/showthread.php?t=222403&goto=newpost Thu, 20 Jun 2013 00:47:37 GMT I have a 95 civic dx. And my stereo has no constant and it's extremely annoying. Will someone help me solve this? ]]> Interior / Audio / Electronics EgCivicKid http://www.clubcivic.com/board/showthread.php?t=222403 http://www.clubcivic.com/board/showthread.php?t=222402&goto=newpost Thu, 20 Jun 2013 00:43:18 GMT Ok so I started with my civic bare stock and not running. After about 3 weeks of diagnosing, it turned out to be the fuel pump, regulator, and injectors. It's still only running on 3 cylinders. Working on that. After a new plasti-dip Paintjob ( soon to be gloss) , I added a front and rear lip kit and a ricey wing ( which I have sold ).
Added a new hi-flow exhaust and new 10.2 mm NGK spark plug wires. Also upgraded to 17" StreetEdition rims and tires. Bought 2" lowered springs, but have yet to install them. Also haved blacked out the tails and painted the rims black. I am working on cleaning the car up, but it is a slow process.







]]> Show off your 5th Generation Honda Civic (1992-1995) Loaf31 http://www.clubcivic.com/board/showthread.php?t=222402 http://www.clubcivic.com/board/showthread.php?t=222397&goto=newpost Wed, 19 Jun 2013 19:21:02 GMT I'm trying to figure out where I would relocate this to make room to mount the 3 Point Strut bar. One of the two bolt holes needed to mount the 3rd point of the strut bar is taken up by this.

]]> Wheels / Tires / Brakes / Suspension aeraiva http://www.clubcivic.com/board/showthread.php?t=222397 http://www.clubcivic.com/board/showthread.php?t=222396&goto=newpost Wed, 19 Jun 2013 17:24:03 GMT Having a bit of a problem here new to site but maybe some one can help. I have 91 civic hb, dohc zc swap with what appears to b zc trans / si. Running 90/93 integra axles , what a lot of people say to do, have only had the car for a week or so, got it from a buddy. Problem is is that theses... Having a bit of a problem here new to site but maybe some one can help. I have 91 civic hb, dohc zc swap with what appears to b zc trans / si. Running 90/93 integra axles , what a lot of people say to do, have only had the car for a week or so, got it from a buddy. Problem is is that theses axles appear to b too short because they pull apart at the cv joints. Now I've seen and heard a lot of different things but most said those axles should b correct. In my case wrong, but also stock axles for 91 civic don't work due to the trans side is to small on the spindle teeth. And ideas before I gotta go deep pocket for custom axle???? Help please ]]> Engine Tech / Drivetrain Thatdumbhbguy http://www.clubcivic.com/board/showthread.php?t=222396 http://www.clubcivic.com/board/showthread.php?t=222395&goto=newpost Wed, 19 Jun 2013 17:07:14 GMT going shopping soon, whats the best trany i can put into my crx, it has b18a1 now i might pick up a jdm 98 b18 what would go well with this going shopping soon, whats the best trany i can put into my crx, it has b18a1 now i might pick up a jdm 98 b18 what would go well with this ]]> Engine Tech / Drivetrain drac http://www.clubcivic.com/board/showthread.php?t=222395 http://www.clubcivic.com/board/showthread.php?t=222394&goto=newpost Wed, 19 Jun 2013 15:58:35 GMT I have a 91 civic Oh, and 3rd Gen zc motor swap. Pretty sure its the matching zc transmission. . Using 90/93 integra axles but pulling them in half when turning. Obviously they are wrong. Only had car for a week but kinda getting old already I have a 91 civic Oh, and 3rd Gen zc motor swap. Pretty sure its the matching zc transmission. . Using 90/93 integra axles but pulling them in half when turning. Obviously they are wrong. Only had car for a week but kinda getting old already ]]> 4th Generation Honda Civic (1988-1991) Thatdumbhbguy http://www.clubcivic.com/board/showthread.php?t=222394 http://www.clubcivic.com/board/showthread.php?t=222393&goto=newpost Wed, 19 Jun 2013 15:17:31 GMT I tried to copy compact video cassettes to dvd on a dvd vhs recorder. It tells me it is protected. Is there any way to copy these. I tried to copy compact video cassettes to dvd on a dvd vhs recorder. It tells me it is protected. Is there any way to copy these. ]]> Off Topic cord http://www.clubcivic.com/board/showthread.php?t=222393 http://www.clubcivic.com/board/showthread.php?t=222391&goto=newpost Wed, 19 Jun 2013 13:34:03 GMT Ill be taking my EG hatch to the strip this weekend for some fun runs. I have a b18b swap Falken ziex tires Neuspeed sport springs Stock otherwise Any tips or tricks? My buddies taking his h swapped accord( bolt-ins and cams) .. Do I stand a chance haha?? Ill be taking my EG hatch to the strip this weekend for some fun runs.

I have a b18b swap
Falken ziex tires
Neuspeed sport springs

Stock otherwise

Any tips or tricks?
My buddies taking his h swapped accord( bolt-ins and cams) .. Do I stand a chance haha?? ]]> Street/Track 92lseg http://www.clubcivic.com/board/showthread.php?t=222391 http://www.clubcivic.com/board/showthread.php?t=222388&goto=newpost Wed, 19 Jun 2013 13:27:42 GMT Is it just me or are parts for the 6th gen Civics, and hatches in particular, getting harder to find? I'm talking about used parts. It doesn't seem to make a difference what part I'm looking for, none of the yards around here have what I'm looking for. This is getting stupid!!!! :x ]]> Off Topic ny00Civic http://www.clubcivic.com/board/showthread.php?t=222388 http://www.clubcivic.com/board/showthread.php?t=222387&goto=newpost Wed, 19 Jun 2013 05:50:26 GMT hello every one,. I am trying to sell my car iv posted 2 adds on gumtree and also on ebay and also put 2 signs up in my cars,how long does it normaly take to sell a car private my insurance runs out on the 20th of this month,. hello every one,.
I am trying to sell my car iv posted 2 adds on gumtree and also on ebay and also put 2 signs up in my cars,how long does it normaly take to sell a car private my insurance runs out on the 20th of this month,. ]]> Should I Buy? -or- What is This Worth? Chan Makhna http://www.clubcivic.com/board/showthread.php?t=222387 http://www.clubcivic.com/board/showthread.php?t=222386&goto=newpost Wed, 19 Jun 2013 05:49:01 GMT Guys,. I am looking for a website that sales Camaros, Mustangs, or Challengers for a weirdly discounted price. Usually you have to ask around for a website like this. need help,.? Guys,.
I am looking for a website that sales Camaros, Mustangs, or Challengers for a weirdly discounted price. Usually you have to ask around for a website like this.
need help,.? ]]> Off Topic Chan Makhna http://www.clubcivic.com/board/showthread.php?t=222386 http://www.clubcivic.com/board/showthread.php?t=222383&goto=newpost Wed, 19 Jun 2013 04:11:19 GMT I'm about to purchase a Blackworks 3 Point Strut Bar and need a little guidance on how to install this into my 97 Civic HX.

Below is the picture of inside my bay (for now). And below that, the picture of the strut bar being purchased. When I looked at my bay, I couldn't see where that 3rd point would attach to on my car. I see one bolt sticking out but something is connected to it. The other possible hole is temporarily covered with a light piece of plastic. Like a clip covering a temporary hole. Is this potential hole what I would mount the 3rd point to? Well, that one and the one being used?

By the way, in the first image, I drew in the Strut Bar where it would go (obviously) and pointed out the two spots in question. I actually popped out the little white plug in the first "?" and there is indeed a hole there but it almost doesn't seem flush with the second "?". The one that has something attached to it already.





Thanks guys for your help in advance. If you need anymore info, I'll be more than glad to provide it. ]]> Wheels / Tires / Brakes / Suspension aeraiva http://www.clubcivic.com/board/showthread.php?t=222383