blown motor rebuild...

[jon31562]

well i have been throwing around the idea of a rebuild and now my head gasket is blown as well as a burnt ring or two... so here is the plan...

bottom end:
original d15b1 block bored 40 over
76mm p29 pistons
npr rings
fully ballanced rotating assembly
acl race bearings
water pump
oil pump
new seals etc. etc..

top:
z6 v-tec head
3 angle valve job
new valves springs retainers...
y8 head gasket middle layer removed
blox stage 2 cam
adjustable cam gear possibly skunk
arp head studs

other:
new oem clutch kit
resurface flywheel
new axles

bay tuck... as best i can...

will update with pics as soon as i get new batteries for my camera...

any suggestions please let me know...

[darkbomb]

GL with the build, get some pics up soon, always like seeing shit in progress :werd:

[Kensai]

any suggestions please let me know...

Yeah. Have the pics ready before you make a thread...

[jon31562]

well i got my motor out tonight...

http://s654.photobucket.com/albums/uu267/jon31562/

its a slide show... but i haven't figured out putting pics on here yet...:(

[sohclubkid]

what rods are you running? be careful with the valve clearance...

[DxHatchGirl]

GL with the swap! :thumbsup:

[jon31562]

i'm getting the machine shop to tell me what stuff i need as far as all bearings crank and all i'm taking it to precision crankshaft in jax. fl, i've been told good stuff about them... and its kinda gonna go slow bc i gotta wait on money...

on the work side i got the head seperated today... i couldn't see where the head gasket was busted but i had really really bad buildup on my pistons and in the combustion chambers... i need new head studs... anyone know where to get some arp for cheap let me know...
i'll post pics tomorrow morning...

[sohclubkid]

what rods are you running? be careful with the valve clearance...

[jon31562]

i'm gonna let the machine shop tell me which ones to get... to line up everything as far as clearances and what not...

[jon31562]

well i lost me job right after i blew my engine but i got it rebuilt finally and its in the car and running... now my new rear main is leaking and my brakes went out but i'll get more pics online tonight...