endo617's 98 Civic LX Project: Balance

[mportedcivicsi]

Those look familiar

 

[endo617]

Those look familiar

Lol who knows maybe i should paint the sedan EBP too. Setups are going to be alike soon.

 

[mportedcivicsi]

Haha! Its not a bad color choice at all

 

[endo617]

Few more parts came in, going to be a crazy spring adding all these mods.

 

[endo617]

Prothane front sway bar bushings and endlinks, installing my front bar back on.

Low Temp TStat

H22 290cc Injectors

I was looking for a good set of CTR/ITR +99 Spec Cams but no luck. Stage 1 S2 was the mildest cam I could find.

 

[endo617]

1991 Civic SI: Volvo turbo and adapter fitted, need to get some studs to bolt it up proper.

 

[xxBLOOD88SHOTxx]

Small turbo= instant wheel spin fun anytime.

 

[endo617]

Small turbo= instant wheel spin fun anytime.

Thats the plan, 10:1 compression and small turbo

 

[endo617]

91 Civic Si:

The way the turbo is set up I need studs to bolt it up

Volvo turbo comes with m8 bolts and studs, had to bore out to fit through M10 studs.

This needs to be shaved to fit a nut.

 

[endo617]

Almost done, adapter plate on. T Pipes for the turbo water cooler lines are in.

 

[endo617]

Buddy gave me his subframe because he went RHD. No more snapped screws, so I can put my front bar back on.

Also gave me a complete Eibach sway bar kit

T Fittings weren't actually 1" like they said. Had to improvise.

 

[endo617]

No more chasing wiring, picked up a complete dash harness and EX engine harness.

 

[endo617]

Progress was made today

Intercooler needs two 90 elbows to be bolted up official

Ordered a new BOV pipe, this one is 2" need 2.5"

 

[endo617]

battery location was too tight, Deka etx14 came in, I'm making a tray for it. This is NOT where it's going to be when I'm done.

I'll be using the M8 holes in between the battery to bolt the tray I'm making.

Went to Race Depot (Home Depot). This is my tray making material

 

[endo617]

Freebie LCA, going to rebuild and polish

Battery bracket made. Need to cut the extra metal and paint it.

New BOV pipe came in too

Waiting on the tie down.

 

[mymmeryloss]

Coming along nicely

 

[endo617]

Some parts came in for the Hatch.

 

[endo617]

Here's the after on the LCA's, half ass polish

Catback came in for the EF. New radiator is in there too with slim fan and shroud, forgot to take a pic.

 

[endo617]

Making brake ducts, using these cheap EG ones and making them fit.

Need to trim the left corners a bit to make it look better.

 

[endo617]

Picked up some new Skunk2 camber kit for $100