Hmm I wonder if i could use this on the surface rust i have on the rear quarter panels before a ghetto aersol respray =)
Its not like rust convertors that turn into a primer right?
http://www.partstrain.com/store/?N=0&VN=4294967166+4294962818+4294962796&Nr=AND(part:Bumper+Cover,universal:0)&sv=0
Not sure if this is too common. Stumbled upon it
May not fit well/be fully reliable. Just showing everyone
Thanks for the posts. Don't mean to revive an old thread. Just wondering if anyone has the diagram for the harness inside the actual door (the part the rubber tube connects to ) for the driver?
Some may remember I tried to repair a harness before...didn't go so well :suprise:
Does anyone know where I can find this harness, apart from wrecked cars/part outs?
Would it be possible to remove this dent with a suction cup/clamp or compressed air + air dryer?
Someone tried to vault over the car, and dented the hood:cry: I've kept it safe for a long time, took a few seconds to ruin it all.
I'll try out a toiled plunger and report back later.
Update
I got all four pins out. As it turns out, you need to just push them out with force (directly)
Sadly, At first, i thought you needed to unlock something, and i ended up partially ruining two of the pins...
I placed this project on stall for a while - back on it now!
Is there a specific way to remove the dang pins on the connector? I can't seem to get them out for my life. Tried pressuring it in multiple ways, but won't budge.
I'n going to try out the method to get out ECU pins next...
would it be possible for you to cut the harness that goes into the driver door and just sell me the connector? (with a few wires attached so i can "hack job" it into my civic?)
I'm not sure if you'd allow it since it might kinda ruin the rest of the harness.
EDIT
DAMNIT
I'm sorry for asking this, as i feel it's been asked before. I tried to search, but cannot find the information i require.
I am unsure of the correct offset for a 1999 Honda Civic Se Sedan (4 door). I'm searching, and will post again here if i find it.
Would a 15 inch rim with these...
Where can you get one of these? I'm going to search now! Didn't even know we could get this!
Found one! Does i thave cupholders for the people in back?
Thank you so much =)
I believe this is the same for both passenger and driver. I never realized the harness going to the doors was called a "floor harness"
Both my front door's are ruined
The connector/harness in my door has been practically completely ripped from the rubber grommet, and nothing in the door works. I need some help determining where each wire goes in the harness.
The wires that go to the door through a rubber protective piece have been completely ripped from...