Search results

yeah, unfortunately whoever had the car before me put the rod ends on backwards, so i spun two rod bearings. So this is gonna turn into my build thread tomorrow! the plan: New wastegate Eagle H Beams Vitara Pistons ACL race bearings Block honed and some other stuff. im looking to up...

Thanks for the clean comments. The kit is ok, it didn't come with one of the oil fittings and I had to fab the intercooler piping where it was supposed to be bolt on. They had shitty customer service, I even had to grind down the manifold to fit my power steering. When it was supposed to be...

if the car is basemaped, its already chipped. Unless its just the p72 hes running. Find a tuner and plug n play.

Im in the process of cleaning up and tucking what i can in the bay right now. Sorry for the clutter!

I have yet to get it dyno'd. But the tuners estimate is around 200 on 7 pounds.

hey guys, i have been lurking these forums for about ten months now. Gaining alot of knowledge. I figured it was time for to start my own thread. Im 18 years old, and ive been in the game for about a year and a half now. Majority of my time and money go into my civic. But, before i had my...

Hey guys, i had a z6 in my 94 EX Coupe, the valves were bent in the head. So i swapped over a complete new z6 head, used all new gaskets as well as ARP Head Studs. But, whenever i accelerate it bogs down a little bit, then goes fine, then will bog down every 1500rpm. Could anyone give me...

check out the yonaka catback exhaust. about 260$. It has a nice tone and isnt very loud. deep purr tone.

osiris, drive down to FL. ill trade your hatch for my EX COUPE with Z6 and sunroof. i want a hatch =/

is this going to be a race or street car? gsr turbo would be cheaper and easier. atleast i would think so. k series would be alot more work and cost probably x2 as much. But its all up to you, this is your build, if your not going to be happy with it or half ass it dont do it at all.

Uploaded with ImageShack.us 94 EX, Fully loaded. Interior: Pioneer radio. Altec research 6x9 x2 motor: D16z6 No-name header Custom cat back to tenrai muffler Spectre cold air. Rebuilt bottom end for low compression, not sure exact specs. exterior: Full Lips JDM pink tow-hook...

got trolled?

sounds like a party.

im pretty sure just about any torque wrench would do. I assume if its just a normal motor and not pushing a crazy amount of hp where you need everything secure anything would do.