Search results

usually your firing order will be printed on your intake manifold

thanks everyone for all the input... as far as doin a full b-series swap, i wish i had the money.. eventually thats my intentions, and it may cost me longer in the long run to do the auto many swap, then swap a b motor, but i can't afford the b swap, yet, and my tranny's not gona last me through...

it appears everyone has confusion as far as what a governor is. In an automatic transmission valve body, you have TP and GP (throttle pressure and governor pressure). The more engine load (the more you press on the gas), the higher your throttle pressure will go. The faster your car travels, the...

i have a similar problem... i initially adjusted the rubber stoppers, but that wasn't enough... check to make sure ur hood is sitting straight. mine dips down slightly on the passenger side, and lifts up slightly on the driver side... actually i found out that its from leaving the hood open, it...

impossible to see without removing the oil filter... ALSO be careful when taking it out of the breather chamber.. mine cracked in half and i had a hell of a time getting it out

thanks for the help... cylinder head gaskets looked similar so i thought it might be possible to keep my bottom end parts.. o well haha thanks

thanks... let me know if u come into any problems i should prepare for lol good luk to u too

i definitely will... thanks a lot for the help... i'm at work now but i'll im u as soon as i get a chance.... thanx again

what kind of sound is coming from your catalytic converter???

thanks.... u think there parts list is good? or did they forget things? ALSO can i use the same tranny mount and just relocate it?? or is a new one needed?

hardest part is cutting the holes... be very careful and take ur time when ur doin it... i recommend a high rpm dremel with a small bit... any more help POST IT i'll try and help

anyone ever do it?? my auto tranny's shot and i would much rather a manual transmission anyway.. ANY information would be appreciated.. i think i know most of the parts, jus lookin for the step by step, but ANYTHING would be appreciated... thanks!

i have a 99 coupe ex with a d16y8... is it possible to just swap the head with a b16??? i figured i'd check to see if the gaskets were the same.. the bolt patterns looked similar, but they were different part numbers.. so that just confused me.. i'm really hoping i could do this without changing...

if it did the same thing on the other side i'm going to say its the bulb... after a while the bulb will take a little more power to ignite, and your ballasts may have a little more trouble igniting them.. a good way to save your bulbs AND your ballasts on your aftermarket HIDs would be to...

i believe its the same harness if you have an EX... here's a link where you would normally purchase adapters for wiring harnesses when doing an engine swap http://www.rywire.com/store/index.php i dont see anything from an ex to an si motor, which makes me think there is no change in the...