Crankshaft Position Sensor

[SilverEXCoupe]

Where is the crankshaft position sensor located on a 00 Civic EX? The scanner showed trouble code P1337 CPK2, and I picked up a new sensor at the parts store.

 

[SilverEXCoupe]

Looks like its under the timing belt cover, and at the bottom. Crap!

 

[Evan.]

Yes, basically on the oil pump.

 

[knightxrider1]

yea its down there. are your valves clicking badly? i think valve adjustment would make that go away. and my alternator belt chewed one of my harnesses make sure thats not it too.

 

[SilverEXCoupe]

yea its down there. are your valves clicking badly? i think valve adjustment would make that go away. and my alternator belt chewed one of my harnesses make sure thats not it too.

Nope, no clicking.

 

[wazup_74]

I have the same code but I haven't checked it out yet. How much was the sensor? Hopefully it's not too hard to replace. I have a lot of clicking and did a valve adjust recently and its still there. Maybe i just didn't do it right...
Good luck, take pics

 

[SilverEXCoupe]

I have the same code but I haven't checked it out yet. How much was the sensor? Hopefully it's not too hard to replace. I have a lot of clicking and did a valve adjust recently and its still there. Maybe i just didn't do it right...
Good luck, take pics

For my car it was $24. But it sounds like a pain to replace.

 

[Evan.]

$24 seems very cheap.

 

[SilverEXCoupe]

$24 seems very cheap.

Well if you look online at Advance they have them for anywhere from $24-150.

 

[knightxrider1]

i would go to honda

 

[jams_ek]

to take it off you have take the drivers side motor mount off and jack up the engine I've done it its a pain in the ass