jdmjml
New Member
Hello, i just installed a B18C into my 92 hatch running all obd1 electronics with a chasebays tuck harness.
My problem is that when i crank the engine it immediately fires but it will rev up to about 3-4k and then hesitate and die. The fuel pump runs and primes and has pressure at the rail. I also put a brand new distributor on it. Cels im getting are o2 sensor and crank position sensor. Any advice that may hellp me get it running correctly would be greatly appreciated, thanks.
My problem is that when i crank the engine it immediately fires but it will rev up to about 3-4k and then hesitate and die. The fuel pump runs and primes and has pressure at the rail. I also put a brand new distributor on it. Cels im getting are o2 sensor and crank position sensor. Any advice that may hellp me get it running correctly would be greatly appreciated, thanks.