No Power to Injectors

[Da1Chubby704]

I Have a '95 Dx that I just did a full swap to a 1.6 from the standard D15. I was running a mini swap using harness an ECU I completely went 1.6 the car wont fire no power to the injectors. Relay is new an nothing look broke, burned or damaged in the circuit. Any ideas?

 

[MistahJuice]

Check your G101 ground on the thermostat housing.

 

[Da1Chubby704]

Ive cleaned the thermostat ground checked the wire an for continuity. Found out there wasnt any so I ran another ground from the thermostat housing to the valve cover now its showing continuity. Also my ECU only shows codes for Vtec a code 21 an I know Vtec isnt hooked up? Is that the problem is the Vtec keeping it from running? Ive tried everything else. But im trying to wire the Vtec an Vtec oil pressure regulator wires into the sub harness because its the stock d15 subharness everything else is D16z6.

 

[gugiey]

You need to see if your are getting power out of your main relay .

 

[Da1Chubby704]

it clicks when I go to crank the car an when I stop trying to crank it. Is that suppose to happen?