Search results

Before I purchase a new intermediate shaft I would love some input from my fellow honda modders. I have a 1991 si with a b18b1 block and a ys1 tranny. The half shaft and intermediate shaft are 94-01 integra, i replaced the axles when I bought it but never bothered with the int shaft because i...

Hey, I have a question for anyone who is familiar with the wiring in an ignition switch from a 91 si. I am attempting to install a push button start, fully bypassing the ignition tumbler. No "put the key in first then press the button" as I've heard of people doing. So, there are 7 main...

Hey, so I have this civic... Bought it off a guy who swapped the engine with a b18b sporting a ys1. It was also converted from auto to manual... A lot of wires going nowhere and most just electical taped. No reverse lights, engine fan is always on, clutch saftey switch wired to always be...

So here is a good one... Left my headlights on this morning while I was at work, came back and car was obviously dead. Jumped the car drove it to Tim Hortons, started right back up, just about home and I'm sitting at a light and my stereo dies, along with everything electrical in the car...

Hey all, I have only found one forum that was relatively close to what i'm experiencing and it turned out to be his main shaft bearing. Anyways, here I am. I have a 91 civic hatch with a B18B1 swap, YS1 GSR transmission with GSR axles. It's a manual transmission, shifter and linkage from the...