D15B7 and D16Z6..... PLEASE HELP ME WITH HARNESSES

slambed_civic

New Member
Registered VIP
5+ Year Member
10+ Year Member
#1
i want to know if the D16Z6 and D15B7 harnesses are the same..... will vtec properly engage.... and also, ive been looking for wiring diagrams for the past week and a half on this conversion... i need to know: what wires need to be run, and where they go, ANY help would be greatly appreciated, Thanks in advance, Jason
 

99CX

New Member
5+ Year Member
10+ Year Member
#3
Chill out dude, your post were 3 hours apart, give people time

No, the harnesses are not the same, you will need to run wires for VTEC plus you will need all the vtec parts (solenoid etc)
 

slambed_civic

New Member
Registered VIP
5+ Year Member
10+ Year Member
#4
sorry bro, im just used to a little quicker forum... i often forget the amount of members at easch forum i vist for information.... then engine that im putting in has the whole vtec setup on it, i pulled EVERYTHING out of the car... so i think ill be ok with the D15B7 HArnesses, so far everything has plugged up.....

ps and in that 3 hours......... engine went from hangin in the air, to in the car and bolted up...

thanks man! :D
 






VigLink badge