Haviing problems reading cel codes

daoshao

New Member
5+ Year Member
i got a b18a block with a b18b head installed. I must assume im running rich due to some grayish smoke and strong fuel smell. I do know that the car does throw a cel...but everytime i try to read the code all i get is a solid cel. It does not blink at all. I've used a paper clip to jump the terminals and thats all i get. any suggestions??
 

stolibears

Use your dipstick Jimmy!!
Registered VIP
5+ Year Member
10+ Year Member
15+ Year Member
daoshao said:
i got a b18a block with a b18b head installed. I must assume im running rich due to some grayish smoke and strong fuel smell. I do know that the car does throw a cel...but everytime i try to read the code all i get is a solid cel. It does not blink at all. I've used a paper clip to jump the terminals and thats all i get. any suggestions??
I did the same thing, but found out that it wasn't shoving the paper clip in far enough. After another try, I started getting flashing.
 




Top