Hey over there, another non civic build thread!

xxBLOOD88SHOTxx

Surge Master
Registered VIP
So as some of you may know, I don't drive a civic. So here is my DA. Nothing special, B20b with GSR trans.

Slowly making it acceptable ya know

When I owned it in Cincinnati, think this pic is late 2009



As I got it after buying it back after 3 years



First...... giant DA steering wheel had to go, so ITR momo in




LCAs were a b****, actually had to cut one bolt out completely on either side of the strut and punch the rest of the bolt out



Got the GC/AGXs in, toooo low lol this thing will HATE Memphis street haha. You can kind of see the mugen lip here I just put on.



Also installed a Buddy Cluc racing spec shifter, it is stiff is f*** and I'm not a fan. It might get better as a wear it in.

That's it so far, hopefully getting tires for my Drags tomorrow and hopefull it can be aligned.



-Brandon
 

R3dline

Respected
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
15+ Year Member
Nice, i always liked the da, good looking car man.
 

xxBLOOD88SHOTxx

Surge Master
Registered VIP
Nice, i always liked the da, good looking car man.
Thanks.

Ordered new calipers for the rears, the right rear was so seized that we couldn't push the piston back in even with a C-clamp. Soo running with only one pad in the right rear lol. Good thing being lowered has slowed me down a lot.

Overnighted some new bump stops from GC too.
 


Hecz

New Member
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
sircks wheels. nice.
 

xxBLOOD88SHOTxx

Surge Master
Registered VIP
Rims on, couldn't do alignment today (need upper balljoints)





Definitely need side skirts of some type lol

Hondata S300/Yonaka dualcore (halfsize) with shroud and slimfan/new front LCAs all on the way.
 

xxBLOOD88SHOTxx

Surge Master
Registered VIP
Small update, PIMP components came in yesterday =)



Uploaded with ImageShack.us

Also on standby....

Yonaka halfsize dualcore radiator
Junk2 camber kit
Genki Tuning catback
Reman rear calipers
BNIB front lower control arms w/moog balljoints
 

crash!

Avi, pull your socks up.
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
Gahhh I love me a DA...
 

crash!

Avi, pull your socks up.
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
Duuuuuuuuuude there has been like 3 CLEAN GSRs for sale on G2IC in the last few months and not one near me :brickwall:

Have to do with what I got I guess.
Awww :( I would love to build a DA.
 

xxBLOOD88SHOTxx

Surge Master
Registered VIP
Small update, camber kit is on so Tuesday Im going in for an alignment and new front LCAs with new ball joints.

All I need for the turbo kit is a fuel pump and a decent wastegate, I don't trust the knockoff that came with it. Oh and AFR and boost gauge. Trying to decide on frog pod or pillar, or dash mounted.
 

xxBLOOD88SHOTxx

Surge Master
Registered VIP
got a little work done yesterday.....





old GC/AGX setup, struts do rebound when compressed but it started riding like s***

 


Top