Jdm square foglights

[Jose1027]

Sorry for posting such a simple question guys,but I have looked all over google and have only found one write up on how to install foglights on a 6th gen,most of the write ups are for 5th gens..I just have one simple question,how to mount them on the bumper do I have to cut?, well thx in advance

Sent from my T-Mobile myTouch 3G Slide using Tapatalk

 

[2slo4u]

yes you'll have to cut the ends of the lower grille or opt to take the whole inner grille off.

http://www.hondacivicforum.com/forum/exterior-diys-54/fog-light-installation-96-98-civic-65513/
http://www.clubcivic.com/board/showthread.php?t=66852

 

[treeafodo]

I just installed these last week. You have to make 10 cuts on either side from what I remember. So 20 cuts total. I did it with an exacto (utility) knife. It wasn't hard at all. Just make sure you know what your cutting before you cut it to prevent a costly mistake.

 

[Jose1027]

Thank you

Sent from my T-Mobile myTouch 3G Slide using Tapatalk