has anyone used a ps9 ecu to control vtec using turbo edit i need to know what i have to do to get this to work...
the problem: pin a8 puts out 11.8 volts all the time until vtec engages then it jumps to 13.9V i was told to install a pull down resistor to get the voltage to 0V, this should make pin a8 read 0V then jump to 13.9V how do i go about doing this?
the problem: pin a8 puts out 11.8 volts all the time until vtec engages then it jumps to 13.9V i was told to install a pull down resistor to get the voltage to 0V, this should make pin a8 read 0V then jump to 13.9V how do i go about doing this?