ZeroMech63
New Member
K So i need some confort from u guys!!! Just dropped off my hatch at CentralFloridaTurbo this past saturday theyre rebuilding it for me... Just scared read some pros n con of high comp on the G2IC site or w.e and now im nervous/scared of blowing my 3rd motor since im broke after this one. Should i have them put a thicker head gasket??? It is my DD and my goal is 400-450whp on pump gas and 550whp in the future. P.S. Anyone know around whats the most hp i can get out that turbo?
Quick run down:
B18b1 block
Just got Darton sleeves put in
B16a head
Skunk2 Tuner Stg1 cams
SuperTech springs n retainers
10:1 84mm Flat-top Wiseco pistons
Go Pwr rods
Ebay turbo kit (except turbo,bov n wg)
Comp 58/58 Turbo w/Billet wheel(not bb) .60coldside .63a/r hotside
Tial 39mm WG
750cc R/C inj
and ARPs, Cometic and ACL ....ect
Thx for the help!
Quick run down:
B18b1 block
Just got Darton sleeves put in
B16a head
Skunk2 Tuner Stg1 cams
SuperTech springs n retainers
10:1 84mm Flat-top Wiseco pistons
Go Pwr rods
Ebay turbo kit (except turbo,bov n wg)
Comp 58/58 Turbo w/Billet wheel(not bb) .60coldside .63a/r hotside
Tial 39mm WG
750cc R/C inj
and ARPs, Cometic and ACL ....ect
Thx for the help!