Hi all, I chipped my 1994 d15b7 (actually, the ecu had september of 1993 stamped on it in ink. Anyway, I added the prom chip and the other IC needed, two capacitors and the resistor and a switch in place of the jumper so I can switch back and forth between stock and modified ecu's.
Now, the check engine light never turns off. the engine does start, there is absolutely no difference between the stock program and the modified one. the engine is running in safe mode, very rich, won't rev above 4000 rpm and has no power. It does not matter which position the switch is in, the engine remains in safe mode with the engine light on. I checked the wiring again twice, reflashed what was supposed to be the P06 stock base program multiple times and the results are always the same. I've removed power from the battery to try reseting the processor. I'm not sure what to do next. Am I not loading the complete program? I've been using a base program provided by both uberdata and chrome. I've flashed using both the flash program provided by Moates and used the Chrome flash program and the engine runs exactly the same no matter what I do. I am wondering about removing the capacitors, resistor and the other IC that supports the Prom, the prom I can remove since it's in a zif socket. I am now wishing I had put the other supporting IC in a removable socket. dang! Is there something else I am supposed to be flashing on my prom? I've noticed that the Moates flach program for Burn1 starts the mods at address 8000 and not at 0000
any ideas? I would like to keep driving my car again monday.
thanks,
James
Now, the check engine light never turns off. the engine does start, there is absolutely no difference between the stock program and the modified one. the engine is running in safe mode, very rich, won't rev above 4000 rpm and has no power. It does not matter which position the switch is in, the engine remains in safe mode with the engine light on. I checked the wiring again twice, reflashed what was supposed to be the P06 stock base program multiple times and the results are always the same. I've removed power from the battery to try reseting the processor. I'm not sure what to do next. Am I not loading the complete program? I've been using a base program provided by both uberdata and chrome. I've flashed using both the flash program provided by Moates and used the Chrome flash program and the engine runs exactly the same no matter what I do. I am wondering about removing the capacitors, resistor and the other IC that supports the Prom, the prom I can remove since it's in a zif socket. I am now wishing I had put the other supporting IC in a removable socket. dang! Is there something else I am supposed to be flashing on my prom? I've noticed that the Moates flach program for Burn1 starts the mods at address 8000 and not at 0000
any ideas? I would like to keep driving my car again monday.
thanks,
James