Crank but won't start HELP

[EK Devil]

I have everything plugged up...its a 94 gsr converted to obd2.....the motor cranks and when I jump start it...it doesn't start...it sounds like its about to start but it won't....the only thing I haven't finish is putting the tranny fluid. please help...i also swapped my SOHC injectors into the gsr...

 

[EricDaReDD]

Check the timing? My car was doing the same thing and then I discovered it was a tooth and a half off...

Peace and Llove
Eric

 

[EK Devil]

Yeah...some folks said you have to get the motor started to do the timing is that true?

 

[EricDaReDD]

I put a chopstick in the first cylinder and turned the crank until it was as high as it would go before coming down (TDC) and then checked the marks on the cam. I put the cam where it was supposed to be and it started right up first try! Good luck!

Peace and Llove
Eric

 

[EK Devil]

hmmm

 

[k20a2tony]

i think u should put back the gsr injectors andcheck if it has spark..and if it does the thw fuel just remove the fuel line and crake it ..it should throw gas..check that let me know what happens

 

[k20a2tony]

and if it does not throw...it ur gas pump

 

[k20a2tony]

oh i hope u changed ur distributor to obo2

 

[Rex_89]

Also make sure the cam timing is right. If it sounds like this, then your cam timing is probably off....

http://www.youtube.com/watch?v=3aioOMR1TrQ