Estimated Power? how much do you think? b18b1 built bottom end

[lightpost08]

Eagle Rods
Wiseco Pistons 9:8:1 Flat tops 81.5mm
Wiseco Rings
Polished Factory Crank
Hot Tanked and Bored to 81.5MM
King Bearings
All new OEM Gaskets
OEM Water Pump
OEM Oil Pump
OEM Head Gasket
OEM Timing Belt
OEM Tensioner
ARP Headstuds Not Included!!!
Block Code: B18A1

the guy is selling the block for 1200, is that a good deal?

and with a stock b18b head how much would this engine make about n/a?

How about with a stock b16 head n/a?

 

[Kensai]

If I say ~180 will you promise me to never post a question like that again?

 

[lightpost08]

If I say ~180 will you promise me to never post a question like that again?

lol, only if it is a reasonable estimate

 

[vandynamics]

Assuming the motor was put together well, you could presumably make in the 300's reliably with the proper power adding setup, and correct air fuel ratios. If you plan on slapping a "stock" head onto the block, without any power adders it is reasonable to assume you will make the power to the equivalent of the motor that the head comes from. In other words, if you put a b18c head on the block, you could roughly estimate the same power as a b18c. In my opinion this is logical, and emphasizes the necessity of a power adder for those searching big power from honda motors.