unix4linux
New Member
K24A4 Block w/ K20A2 Head
I have a K24A4 block with a K20A2 head that I was building for my RSX. I decided to work on another project and selling this build. I am selling everything for $6,000 OBO shipped or parted out as follows: bottom block is parted as one and head is parted out as one. OR, I am willing to separate from the bottom block as follows: block w/ everything except pistons on its own and rods on its own.
The head I am willing to part out as: head with complete valvetrain and everything else OR cams on its own.
Details of bottom and head:
K24A4 bottom: $3,000
• Stock crank
• Complete bottom end
• All bolts and nuts
• Stock pulley
• Oil pump
• Oil pan
• ACL bearings and thrust washers
• CP Pistons 9.0:1 89MM
• Eagle H-Beam Rods
• Golden Eagle HD Sleeves with copper o-rings
• Honda OEM head gasket 89MM
K20A2 head: $3,000
• Skunk2 Stage 2 camshaft
• Rocker assembly
• All lost motion with springs
• Race spec port and polish (maxed)
• Supertech intake and exhaust seals
• Valve job
• Supertech intake and exhaust valve guides
• Supertech keepers
• Brian Crower oversized intake and exhaust valves 1mm
• Brian Crower valve springs and retainers
• Valvecover
• Ignition coil
• OEM camgears
• All sensors for head
• Head was milled slightly just to clean the surface
I have a K24A4 block with a K20A2 head that I was building for my RSX. I decided to work on another project and selling this build. I am selling everything for $6,000 OBO shipped or parted out as follows: bottom block is parted as one and head is parted out as one. OR, I am willing to separate from the bottom block as follows: block w/ everything except pistons on its own and rods on its own.
The head I am willing to part out as: head with complete valvetrain and everything else OR cams on its own.
Details of bottom and head:
K24A4 bottom: $3,000
• Stock crank
• Complete bottom end
• All bolts and nuts
• Stock pulley
• Oil pump
• Oil pan
• ACL bearings and thrust washers
• CP Pistons 9.0:1 89MM
• Eagle H-Beam Rods
• Golden Eagle HD Sleeves with copper o-rings
• Honda OEM head gasket 89MM
K20A2 head: $3,000
• Skunk2 Stage 2 camshaft
• Rocker assembly
• All lost motion with springs
• Race spec port and polish (maxed)
• Supertech intake and exhaust seals
• Valve job
• Supertech intake and exhaust valve guides
• Supertech keepers
• Brian Crower oversized intake and exhaust valves 1mm
• Brian Crower valve springs and retainers
• Valvecover
• Ignition coil
• OEM camgears
• All sensors for head
• Head was milled slightly just to clean the surface