this is going to be a nice thread =] good luck with the swaphahah, thats great...!
Goals for today:
- Simple Green the engine bay
- Tuck all the wires, hide HID ballasts, etc.
- Paint engine bay gray
- Clean up z6 block, paint it silver, put on EBP valve cover.
As a Parts update - I figured...i'll get a new intake..so I ordered the Whale Penis intake. Can't wait till that comes in. Also, I decided to get a light weight flywheel from fidanza. That, along with the exedy clutch has been ordered.hahah, thats great...!
Goals for today:
- Simple Green the engine bay - DONE, just needs to be prepped for paint
- Tuck all the wires, hide HID ballasts, etc. - Ended up removing them so that the bay can be painted tomorrow
- Paint engine bay gray - On Tomorrow's To-Do List....it was too cold to paint today.
- Clean up z6 block, paint it silver, put on EBP valve cover. Cleaned up the block a bit. Once again, too cold to paint.
Show me where you put them! Look at my tuck thread for ideas. I love the spot I put them in.hahah, thats great...!
Goals for today:
- Simple Green the engine bay
- Tuck all the wires, hide HID ballasts, etc.
- Paint engine bay gray
- Clean up z6 block, paint it silver, put on EBP valve cover.
You were running 10ga?! eek.As a Parts update - I figured...i'll get a new intake..so I ordered the Whale Penis intake. Can't wait till that comes in. Also, I decided to get a light weight flywheel from fidanza. That, along with the exedy clutch has been ordered.
Also, we removed the rest of the AC piping/lines, they are all out. I also replaced my 10 gauge amp power wire and ground for 4 gauge, which the amp really needs.
Do it up man. The second I started spraying it down, i got motivated like none other.this motivates me to clean up my bay before my swap comes
You're tellin' me..! ...And i'm running a Alpine M850 amp..which needs thicker wires. Now I think I can get the full power/potential out of the amp.You were running 10ga?! eek.