H&R OE Sport lowering springs. Upside down?

[LatinEM2]

So I'm going to be installing these springs on my car. Last night my bro and I assembled the fronts but the only way that the top hat would sit flush was with the springs logo upside down.
Like this:

I'm pretty sure I put the right side spring with the right side strut:

Any thoughts?

 

[2slo4u]

should be fine..my neuspeed springs sit the same

 

[LatinEM2]

should be fine..my neuspeed springs sit the same

All right cool. Which neuspeed springs do you have?

 

[2slo4u]

I have the neuspeed race springs

 

[LatinEM2]

I have the neuspeed race springs

And are you on stock struts/shocks?

If you can help me out:

Got some pics of the install:

Here is the driver side. H&R vs stock. As you can see they don't wind up the same way :shady:

Then the passage side, same thing:

Could it be because I am using the HFP dust boot/top hats instead of the stock ones? As you can see in the pics the top hats are a little different.

If I flip the log up right, then the smaller end of the spring did not sit flush with the top hat. Maybe it was because of HFP top hat?