JDM 96-98 EK dash clock

Status
Not open for further replies.

VTi_ME

New Member
Registered VIP
5+ Year Member
10+ Year Member
15+ Year Member
Approx 1 weeks time via Airmail
 


cgpEJ6

noob
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
it's a very simple install, just 4 wires that tap into your stereo wiring
 


NOFX

I'm NOT eran!
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
15+ Year Member
unr8ed06 said:
one more question, would i need the whole bezel to make it look flush? if i take the pocket out there's a big hole. for this i'd need the surrounding bezel too right?
You'll have to remove the pocket. Then remove the entire bezel from the car.

Once the bezel is out you can use two screws to fasten the clock into the dash. Remember that the holes on the bezel for the screws are not yet threaded.

You'll have to wire it to the radio wiring and then put it all back together.
ImportFan1 said:
is this just a plug and play? i might be interested.
No, it's NOT plug and play on USDM cars.
 

VTi_ME

New Member
Registered VIP
5+ Year Member
10+ Year Member
15+ Year Member
I can sell it with out paypal =)
 

ImportFan1

Super Moderator
Staff member
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
15+ Year Member
why did you bump this? its over a year and a half old...
 

VTi_ME

New Member
Registered VIP
5+ Year Member
10+ Year Member
15+ Year Member
why did you bump this? its over a year and a half old...
No worries buddy I can still get these,All i need is a list of ppl who are interested and I will source them out
 

NOFX

I'm NOT eran!
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
15+ Year Member
dont low ball him, i payed $105 for mine. there $$pricey$$
That is by far the most I've heard of one going for. I usually hear of $70-90 (tops) for one.
 
Status
Not open for further replies.


Top