electron blueSi
Noob
All parts were used for approx 3k miles unless otherwise specified. The parts were removed from a B16 motor. If you have any questions please ask.
$600 Precision SC61 (P/N#6152E) Turbo w/ .63 A/R. It was run for approx 3k miles. Comes w/ braided feed line & gasket.
$600 unused Love Fab topmount turbo manifold for a B16. It has holes drilled for t3/4.
$150 AEBS Intake Manifold
$210 Precision (Delphi) 880cc injectors
$320 Greddy EBC PRofec B-Spec II
Comes with all the wiring needed to install.
$500 Lenso Drag wheels w/ M&H Racemaster Drag Slicks
The Lenso Drag wheels are 13x7.5 w/ a bolt pattern of 4x100. The M&H Racemaster Drag Slicks are 25x8.7-13 w/ about 5 runs on them. This setup costs around $900 new.
$700 91' B18A1 Block w/ micropolished crank & a 99' Si B16A Head w/valve cover
This is a B18A ls non-vtec block from a 91 Acura Integra. The block was hot tanked then bagged. The crank was micropolished then bagged up. The head is from 99' Civic Si, B16 vtec stamped w/ pr3-4 9|9 1|2 |3 9|0. The head does not have the cams.
$50 MSD ignition 2 step module MSD-8739
$600 Precision SC61 (P/N#6152E) Turbo w/ .63 A/R. It was run for approx 3k miles. Comes w/ braided feed line & gasket.
$600 unused Love Fab topmount turbo manifold for a B16. It has holes drilled for t3/4.
$150 AEBS Intake Manifold
$210 Precision (Delphi) 880cc injectors
$320 Greddy EBC PRofec B-Spec II
Comes with all the wiring needed to install.
$500 Lenso Drag wheels w/ M&H Racemaster Drag Slicks
The Lenso Drag wheels are 13x7.5 w/ a bolt pattern of 4x100. The M&H Racemaster Drag Slicks are 25x8.7-13 w/ about 5 runs on them. This setup costs around $900 new.
$700 91' B18A1 Block w/ micropolished crank & a 99' Si B16A Head w/valve cover
This is a B18A ls non-vtec block from a 91 Acura Integra. The block was hot tanked then bagged. The crank was micropolished then bagged up. The head is from 99' Civic Si, B16 vtec stamped w/ pr3-4 9|9 1|2 |3 9|0. The head does not have the cams.
$50 MSD ignition 2 step module MSD-8739
