well i want to replace my piston rings due to them getting bad...im not too knowlegable with internal stuff so i thought you could just replace them and go on with it lol. i didnt know you had to get it honed as well. my question is, how much do you think a shop will cost to replace my rings? i figured i would get the ITR pistons and rings set and do that all at the same time. will they need to pull the motor and stuff to do this? any info would be greatly appreciated. for those that dont know i have the jdm gsr swap. do you recommend any other pistons? i think the ITRs will be good. also if i have this done, is there anything else you recommend upgrading at the same time. im not looking to fully build my motor or anything. and not planning on turboing it