Question about ODB0 Intake manifold sensors

[deemee]

i have a 89 b16a intake manifold from a ODB0 motor and i plan on using a ODB1 engine harness for my LS/V. I want to transfer the sensors to a skunk2 manifold would this work? and would i need all the sensors from the old intake manifod because the skunk 2 manifold does not have all the provision that my ODB0 manifold has

 

[deemee]

bump for some help, or advice

 

[12.8:1 Ls/vtec]

IAT will fit no problem, the skunk2 IM also has mounts for 2 different styles of IACV's so you should be golden. There really aren't any other sensors on the manifold than that. May have to run some different coolant lines or T a couple together so get ready for that.

 

[deemee]

ok thanks a lot, just wanted to make sure