Whats up people, im restoring a 95 Si hatch, got a lot of work to do, lots of plans, this is the first time i ever do anything this big, i had alot of questions when i first got into doing bodywork, i am by no means a professional, but can get it done and i think i do pretty good...
i didnt wanna sit there goin through 13 pages to see if anybody had made a thread with pix on how to replace the rear quarter panels...
Im in the process o replacing mine, just havent found a good parts car yet...
Driver qp had bad rust, and big dents...i could of easily replaced the lower section of the quarter panel with a replacement panel from fixmyrust.com but theres no point in takin the time to fix rust and big ass dents, so im replacing the entire quarter panel...
The way i cut the qp is how Honda recommends for it to be cut...
Im hoping these pix and steps will help somebody out there that wants to tackle doin theyrs...
Here are some progress pix...
i didnt wanna sit there goin through 13 pages to see if anybody had made a thread with pix on how to replace the rear quarter panels...
Im in the process o replacing mine, just havent found a good parts car yet...
Driver qp had bad rust, and big dents...i could of easily replaced the lower section of the quarter panel with a replacement panel from fixmyrust.com but theres no point in takin the time to fix rust and big ass dents, so im replacing the entire quarter panel...
The way i cut the qp is how Honda recommends for it to be cut...
Im hoping these pix and steps will help somebody out there that wants to tackle doin theyrs...
Here are some progress pix...