Simon1986
New Member
Hi guys, new member so not entirely sure this is in the right place, anyway!!
I recently purchased an EP3 Type R, pre face-lift, but had problems with the fob and Hamilton Palmer alarm from the go.
It got to the point where I was trapped inside the car unable to get out with a broken fob and constant alarm sounding!
Due to this I have removed my alarm - this is where is gets a bit more complex....
Basically I've cut the H&P alarm out from under the dash, reconnected all the wires on the fuse box connection plugs as well as the ABS circuit board, and all was well and good, up to a point ....
Essentially the car will now crank, but won't start, the fuel pump isn't receiving any power, so the engine can't start.
Any tips on how to resolve this?
Thanks
I recently purchased an EP3 Type R, pre face-lift, but had problems with the fob and Hamilton Palmer alarm from the go.
It got to the point where I was trapped inside the car unable to get out with a broken fob and constant alarm sounding!
Due to this I have removed my alarm - this is where is gets a bit more complex....
Basically I've cut the H&P alarm out from under the dash, reconnected all the wires on the fuse box connection plugs as well as the ABS circuit board, and all was well and good, up to a point ....
Essentially the car will now crank, but won't start, the fuel pump isn't receiving any power, so the engine can't start.
Any tips on how to resolve this?
Thanks