Jolting
New Member
So I have my dome light set to automatic. When I open my drivers door it doesn't turn on. It works for every other door. I even swapped the switch on the door around with one that I know works and it still doesn't work on the drivers door. (The Door I swapped it with still works even after the swap) If I leave the key in or the lights on, it makes the dinging noise still. Once in a blue moon it will work properly but soon as I reopen the door it stops again. Is there some plug that could be loose?
Side note does anyone have a diagram showing where the ignition harness is. (Some diagram of the harness its self that tells me what each wire does would be great too) I'm hooking up an after market alarm, and I'm not sure where I should splice the wires for it. Right now I have the 12v and ignition from the radio, but if there is somehing unrelated to the radio, that would be great.
UPDATE
Here is a little update on this. I just installed a brighter led bulb. When the drivers door is open, the light is on but barely. If I open up any other doors it brightens up to where it is suppose to be. So my driver door is giving a low voltage for some reason. Any ideas?
Side note does anyone have a diagram showing where the ignition harness is. (Some diagram of the harness its self that tells me what each wire does would be great too) I'm hooking up an after market alarm, and I'm not sure where I should splice the wires for it. Right now I have the 12v and ignition from the radio, but if there is somehing unrelated to the radio, that would be great.
UPDATE
Here is a little update on this. I just installed a brighter led bulb. When the drivers door is open, the light is on but barely. If I open up any other doors it brightens up to where it is suppose to be. So my driver door is giving a low voltage for some reason. Any ideas?