So I've came to the decision of purchasing an 00 JDM B18c1 GSR motor but want to make sure i've accounted for everything that needs to be replaced for my 00 Ex or ej8... So my first question is if the motor comes wit its stock mounts (B Series) from the teggy, will they bolt right on to my chassis? According to the How-to B18 into 6th Gen thread I need these parts as well... I take it the tranny bracket is separate from the motor mounts?
- Rear tranny bracket from a 99-00 si .. Part # 50827-S04-N10
- Front upper driver side bracket by the timing belt from a 99-00 si .. 11910-P30-000 (Available at dealership?)
- gsr throttle cable
Next, I know i need an extended engine harness b/c of JDM motor but I also read somewhere that I might need an A/C or P/S bracket from delsol or Si? Help would be greatly appreciated as I dont wanna f**k myself over during the swap leavin myself carless for another time period while i search for more parts... excuse me for my ignorance but i have been researching my ass off all over the internet an swap books to figure dis out so plzz help would be amazing!
- Rear tranny bracket from a 99-00 si .. Part # 50827-S04-N10
- Front upper driver side bracket by the timing belt from a 99-00 si .. 11910-P30-000 (Available at dealership?)
- gsr throttle cable
Next, I know i need an extended engine harness b/c of JDM motor but I also read somewhere that I might need an A/C or P/S bracket from delsol or Si? Help would be greatly appreciated as I dont wanna f**k myself over during the swap leavin myself carless for another time period while i search for more parts... excuse me for my ignorance but i have been researching my ass off all over the internet an swap books to figure dis out so plzz help would be amazing!