So my muffler just rusted off the end of my exhaust and I'm looking to replace it with a twin loop muffler, but I have a few questions.
First question is would the OBX twin loop even fit properly on my EJ1?
Then the inlet for the OBX twin loop is 2.5" while I believe the exhaust is 1.75" which leads to my next two questions:
Can I flip exhaust reducers around to make them "expanders"?
If I can, is it wise to weld two reducers together to make up the big difference?
First question is would the OBX twin loop even fit properly on my EJ1?
Then the inlet for the OBX twin loop is 2.5" while I believe the exhaust is 1.75" which leads to my next two questions:
Can I flip exhaust reducers around to make them "expanders"?
If I can, is it wise to weld two reducers together to make up the big difference?