My car's lifelong journey since 2003

[SoJ1Ro]

dude i wish i lived near you so we can work on cars together. you do a good fricken job

 

[808EK96]

Nice work of art!!

 

[Zee]

drop the rear more

 

[im_slow]

thanks guys.

it's decent work for garage work, not the best of course; it'll improve later down the road...

the rear sits fine to me cause i haven't rolled the fenders yet. if i go over a bump or dip hard enough then it'll rub.

 

[DAMN RICAN]

great build man!!

 

[Buckn8ked]

Nicely done !!!!

 

[im_slow]

Here are some new updates people!

I've been lagging on posting this stuff for about a month now but here they are finally...

Skunk2 Pro Series 68mm TB

Skunk2 Cam Seal

MFactory Oil/Tranny Magnetic Plugs

 

[im_slow]

Brembo Sport Slotted Rotors

Hawk HPS Performance Pads

Goodridge G-Stop SS Brake Lines

 

[im_slow]

All brake parts are installed.

 

[im_slow]

Skunk2 Pro Series Front Camber Ball Joints (Had to replace my old ones)

 

[im_slow]

Carbing 3PT Front Shock Tower Bar (Finally after so many years of wanting it!)

 

[im_slow]

Password:JDM 4PT Rear Shock Tower Bar

 

[s_crowley 17]

Looks great..good to see another vsm build with boost !

I like the 4 pt. bar, hows it feel?

 

[im_slow]

Looks great..good to see another vsm build with boost !

I like the 4 pt. bar, hows it feel?

it feels much firmer and goes exactly where i want it to. it was worth it imo, the whole suspension setup to me feels just like what i wanted; turning, straight, smoothness, etc...overall ride quality is great.

 

[Kensai]

Holy welding batman, nice welds! Amazing car duder! Do those wheels rub at all? They look like they're sticking out like an inch in the back lol.

 

[kimmayyy]

nice exhaust tilt

 

[ej8arm]

i have to say this is one of the cleanist builds i have seen in a while.

 

[DarkCreep]

Thats a s**t load of power for a T25 lol..

 

[Beej]

inspirational. Great work. ...and....geez. I've been considering whether or not to weld my own axelback piping for my new Buddy Club muffler I just bought, I think you've just convinced me.

What material was used for your exhaust piping? I wanted to do aluminum to save weight, but I'll be using a wire welder (like you) so aluminum is out of the question. O'Reilly's has "Low Carbon" which I'm guessing is the right sfuff?

 

[ImportFan1]

Very clean build. Did you respray the bay or just clean it up when you had the motor out and did the tuck?