Have one valve stem that doesn't quite match the rest. Even worse it looks like it could cause scratches when adding air.
Just looking for some ideas on the best way to give the new straight valve stem I have a slight bend. Without pinching it or breaking all together.
This is the good one.
The bad...
The only tool I've come across was made in the 50's. The valve stem I have is just a little too short for the brake line bender I have. Unless someone can point me in the direction of a company that makes custom valve stems. Can't seem to find Carving's website either. Plus the wheel has a 6mm hole which makes it more of a pain. Really want to get these on my car by April 22.
Just looking for some ideas on the best way to give the new straight valve stem I have a slight bend. Without pinching it or breaking all together.
This is the good one.
The bad...
The only tool I've come across was made in the 50's. The valve stem I have is just a little too short for the brake line bender I have. Unless someone can point me in the direction of a company that makes custom valve stems. Can't seem to find Carving's website either. Plus the wheel has a 6mm hole which makes it more of a pain. Really want to get these on my car by April 22.