shiroikicker
New Member
July 7, 2011
removed a/c
weighs about 45lbs, no difference as a dd
July 8, 2011
start of my wire tuck
aftermarket grill could easily have been pulled off, oem is the way to go
July 15, 2011
with the removal of the condenser, my block was heating up from the air. Bought some sheet metal to block the air passage
my welder is terrible, any advice for a decent mig?
the one i use isn't gas and cost about 100$. the welds end up horrible but still kept the metal from not moving
July 16, 2011
my new alarm, de-pinning useless wires to make installation as clean as possible
July 17, 2011
..and my ricer days are over. All this useless junk on my car just attracts attention. Now that the car is clean it looks more mature.
July 18, 2011
my high flow cat came in, time to install
a bit of rust proofing while i have accessibility
still need to trim my rear lip, and lengthen the secondary o2 sensor so it can reach the cat
removed a/c
weighs about 45lbs, no difference as a dd
July 8, 2011
start of my wire tuck
aftermarket grill could easily have been pulled off, oem is the way to go
July 15, 2011
with the removal of the condenser, my block was heating up from the air. Bought some sheet metal to block the air passage
my welder is terrible, any advice for a decent mig?
the one i use isn't gas and cost about 100$. the welds end up horrible but still kept the metal from not moving
July 16, 2011
my new alarm, de-pinning useless wires to make installation as clean as possible
July 17, 2011
..and my ricer days are over. All this useless junk on my car just attracts attention. Now that the car is clean it looks more mature.
July 18, 2011
my high flow cat came in, time to install
a bit of rust proofing while i have accessibility
still need to trim my rear lip, and lengthen the secondary o2 sensor so it can reach the cat