1993 Ej1 Testing Waters

[aaronbrooks22]

Motor:
JDM B16 Head
5 angle valve job, ported and polished
B18A1 Block Sleeved to a 2.0 84m.m
SuperTech Valves
Skunk 2 Pro Series 11,000 RPM Springs
Skunk 2 Titanium retainers
Skunk 2 Pro Series P1 Cams
Skunk 2 Pro Series Manifold Polished and ported to match head and throttle body
Skunk 2 68 m.m throttle body
Motech 3 bar map sensor
Cometic Head Gasket .030
Walboro 255 fuel pump
Integra Type R oil pump, water pump and crank
Knife Edge Crankshaft
Eagle H Beam Rods
Arias Pistons 9.2:1 compression ratio
Skunk 2 Carbon-composite fuel rail
RC 750cc injectors
LS Integra Timing belt
Type R Transmission
6 puck unsprung clutch
MSD 6 A Box
MSD External Coil
MSD Cap
Skunk 2 Pro Series Cam Gears
Hondata S300 Engine Managment
OBD1 ECU

Turbo:
Garrett T3/T67 ball bearing water cooled
Dual Tail 38m.m wastegates
Tail 50 m.m blowoff valve
2.5" Intercooler piping and ductwork from AFI
AFI Pro series turbo manifold
PWR Intercooler custom, 3" thick 1' tall 2.5' long
PWR Couplers and clamps

Suspension:
Tein Super Street full coilover , 16 valve dampening force
Skunk 2 Pro Plus Camber kit front
Skunk 2 Pro Camber Kit rear
Integra LS sway bar, rear
Newer Civic Sway bar, front
Rear strut bar, lower tie bar
Skunk 2 lower control arms, rear
Energy Suspension bushing kit

Body:
Shaved emblems, front and rear
Shaved trunk lock
Shaved antenna
16" FTD rims by flick
JDM side molding
Shaved wipers, and motor removal
JDM center console


im lazy so photos can be found here
http://www.clubcivic.com/board/showthread.php?t=173937

up for trades, whatever you have, as long as you think its fair, entertain me, price since i have to post one 14k

parts i have not installed yet
new alpine head unit
pioneer speakers, 6.5's
buddy club fixed position seats
takata 4pt harnness
greddy boost controller
8pt weld in through dash roll cage, with 2 door bars
water-meth injection kit
seibon carbon fiber oem hood, fenders, and trunk deck
enkei 92"s with falken azenis 205 50 15
no name lip
black racing steering wheel
nrg quick release, short v2 hub and lock
new carpet,
skunk 2 weighted shift knob

 

[aaronbrooks22]

no one??? not even a lowball haha

 

[aaronbrooks22]

ttt

 

[rwlsvtec_03]

holy f**king manifold!! twin wastegates?

 

[aaronbrooks22]

indeed,

 

[99civicEx908]

Nice build but i think you should remove the mesh grill from the bumper lol other then that BUMP FOR YOU

 

[aaronbrooks22]

it is removed....if you look at page 5 or 6 on that thread you will see, thank you though, i am going to put some photos on this thread now

 

[cincy_ civic]

nice car!!

want to trade for a 2002 avalanche!!!

 

[aaronbrooks22]

pm sent

 

[aaronbrooks22]

to the top

 

[rwlsvtec_03]

ever taken above 441whp?

 

[aaronbrooks22]

well, currently no. as soon as i get back, i will install the arp studs, a gurdle, run ss fuel lines, bigger injectors and run race fuel, tune to 20 psi, and i hope to make a huge number, nothing in mind just yet, im set in the 615+ area though, i will get it to make 650hp before im done

 

[aaronbrooks22]

to the top

 

[obracer12]

bump for viewing

 

[gioalba]

dayum! glws man, nice set up!

 

[aaronbrooks22]

thanks everyone, im honestly not selling the car, and have zero intentions on it, but everything is for sale for the right price and i just wanted to see what trades people were offering. but thanks for all the kind words

 

[aaronbrooks22]

car is getting a full wire tuck, and new coat of paint...photos to come