SpeedTechnik, why are you asking the exact same question I m asking?
And did you guys read my posts carefully and look at the pics carefully? It obviously exists as you can see it in the pic.
Lethal6 - just because you have never seen this before doesn't really mean much..
I think you to guys are leading each other down a dead end road.
I really don't think I am the one who is "over-thinking" this.
But I appreciate responses.
1) Let me clarify my question: Lethal6, is there a specific engine that you suspect it came from? Would it line up and rid op of worries?
2) I have read every single post at least once and understood them in their entirety. Yes I saw your pictures. It only shows
your mounts are in existence. This can mean that they might have been crafted to look like oem by the shop that swapped your engine and since they are no longer in existence that could mean your mount is discontinued. Any and all details you have shown us hasn't been enough to say where it came from. The best detail you showed us was the picture of your mount twice. This lead to Lethal6 presenting figure nine of a specific engine with a similar mount. The fact he presented this has me question whether that is the mount you have already ordered, which in turn then left me to wonder that if that is the case why isn't it aligning correctly.
3)Although it seems circular, we aren't necessarily going in circles or into a dead end road. It means that at this point we need more info. Our only lead is figure nine, and I doubt you can provide us with anything considering you didn't do the swap yourself.
4) As far as "overthinking this", you may be. It does not appear you have done any research on your swap or that mount. Considering this and the fact that you let a shop do your swap, I'm lead to believe that you feel everything must align since the shop did it. Not everything will be perfect and align correctly because they might have not done a great of a job as you think, but if you have a mount that is almost identical but you have a problem with it because it just does not
really align, then anyone would say you are over thinking it. If you feel strongly about how different they are and how the holes really don't align, why haven't you posted any pictures of the two to compare? Specs? serial, sku, part numbers? I really don't see how we can help when you haven't done your part with the information. we cannot spoon-feed you.