Really sucks on the motor. That is how my built Ls/vtec was, same problem. But did quite well, ran a 13.5 on street tires at 105 mph. Gsr trans too, no Lsd. What numbers did you put down?
Made 204 hp and 150 flb sum s**t ass numbers for what was put into the motor and now the car is at onesix he keeps telling me that its nothing the machine shop did or nothing he did im like that's kinda bull since it had 11 percent leak int he first cylinder and it was the best the worst was 15 percent leak. it should be around 5 percent leak for a brand new motor and the compression has been crazy across the board 275. 265. 285 292yea you mind to tell us what you made? Im curious. You could have done a K swap for 7500 and made 230 pretty easily. With awesome torque.
yea definitely too low, I know a guy with a gsr block with no milling on a gsr head with 12.whatev to 1 and made 213. less tq but more power and yours is alot higher, obviously. They're not gonna do anything for you?Made 204 hp and 150 flb sum s**t ass numbers for what was put into the motor and now the car is at onesix he keeps telling me that its nothing the machine shop did or nothing he did im like that's kinda bull since it had 11 percent leak int he first cylinder and it was the best the worst was 15 percent leak. it should be around 5 percent leak for a brand new motor and the compression has been crazy across the board 275. 265. 285 292
was the compression no numbers are even close to the same and i have 13.5 to 1 comp pistons milled block and head with skunk 2 high comp valves not very happy at all and now im going to wait like 7 months before i even get my car back from onesix cuz mark is a slow ass fool when it comes to anything
im pretty fed up with onesix motorsports at this point
onesix is saying everything is fine witch i can not believe that for a second the thing barley idles it keeps going threw spark plugs and the tune and everything is fine i have a wideband o2 as well everything checks to be fine i think he orders the wrong pistons and there not what the compression he says they are. the head and block were milled all the clearances were checked but the scrub ass machine shop that did my motor doesn't have any recodes of any clearance numbers at allyea definitely too low, I know a guy with a gsr block with no milling on a gsr head with 12.whatev to 1 and made 213. less tq but more power and yours is a lot higher, obviously. They're not gonna do anything for you?