FS: B16A OBD1 Tuck Harness

[Eran]

FS: B-Series OBD1 Tuck Harness

B-Series Tuck Harness - OBD1
It's a half-harness for an OBD1 Civic/Integra/del Sol (or OBD2 del Sol / Integra). Plug and play for any OBD1 B16A/A3/A1. Should also work for an OBD1 B18B1, you'll just have leftover VTEC, VTP, and Knock. Will also work for a B18C5, and a B18C1 if you don't have the stock manifold (dual butterflies). Has some ugly (split heatshrink, a couple wires are buttplugged instead of soldered), but I'm going to try and take care of most of that before I sell it.

MOST OF THE UGLY IS FIXED!

$325 OBO

$350 with firewall blockoff plugs

Before:

After:

Blockoffs:

 

[mikeycivic01]

are any of those plugs for the driver side harness hole?

 

[Eran]

Those two plugs on the end are the driver's side. Also, the fusebox lead.

On that main loom, those are the three passenger side plugs, and the driver's side ground plug (the dead end).

 

[Road Pirate]

Bump for a good seller

 

[Eran]

Bump, I fixed up the ugly.

 

[Eran]

Ttt

 

[mikeycivic01]

i was asking about the firewall plugs

 

[Eran]

Yes, one of them is. I'm not selling it separately.

 

[Eran]

Ttt

 

[Eran]

bump