98Ferio
New Member
I have a 98 civic 4dr and I was looking into just making a regular kill switch but i just went ahead and made a fuel pump kill switch, basically what i did was take out the bottem of the back seat, and you can see the wires for the fuel pump, find the YELLOW wire with the green stripe and i just cut it, and i had already had my switch set up and ran the cable under the cup holder, under the part that is over the shifter, under the arm rest and then just pulled the wires out so i could solder each switch wire to each fuel pump wire... after getting all that done i set everything back up and so if someone would want to steal my car, and the switch is off the car wouldnt crank over because the gas wouldnt be running to the injectors... until i flick the switch on...
parts needed:
wire strippers
electrical tape
heat shrink
solder
soldering iron
either 16,14 or 12 gauge wire, (not speaker wire).. u could but i wouldnt...
1X inline fuse holder
any kind of toggle switch, (there are some with lights, or some without
i wouldnt get one with a light, there are three prongs to solder to so youd have to figure out which ones for light n which ones for power...
if anyone needs step by step or placement questions just either ask through here or you can pm if you would need help figuring out switch places... (ive got a few nice places)
parts needed:
wire strippers
electrical tape
heat shrink
solder
soldering iron
either 16,14 or 12 gauge wire, (not speaker wire).. u could but i wouldnt...
1X inline fuse holder
any kind of toggle switch, (there are some with lights, or some without
i wouldnt get one with a light, there are three prongs to solder to so youd have to figure out which ones for light n which ones for power...
if anyone needs step by step or placement questions just either ask through here or you can pm if you would need help figuring out switch places... (ive got a few nice places)