Help overheating

[spooned209]

Hey guys my engine started over heating tonight i checked hoses and the one under my dizzy had a rip so i ccut it and put it back on and its still over heating there is no cel codes at all.

Its a jdm d15b vtec with aem short ram intake and dc headers

 

[spooned209]

Fan does come on also

 

[RonJ]

Did you bleed the cooling system?

Bleeding the cooling system may take 20-30 minutes.

1) Park the car on an inclined driveway with the front end higher than the rear.

2) Push the dash heater lever/knob to MAX heat.

3) Follow the directions in the diagram below (hint: the bleed bolt is located where the upper radiator hose connects to the engine):

 

[spooned209]

Do i just untighten it never bleed anything b4 lol

 

[RonJ]

Are you able to follow the instructions I posted? Is there something you don't understand?

 

[spooned209]

Im on my phone didnt zoom in lol

 

[spooned209]

If the fan doesnt click on is that a good thing during this process cause it ran for 10 min and while it warmed up never kicked on bit it did kick on when it was over heating

 

[adc253]

yes just loosen the bolt until water comes out. also your thermostat could be stuck closed. which will cause your car to over heat

 

[taluzer45]

I had to fix a overheating problem too, Listen to RonJ, he knows his stuff.... thats why mines fixed! I needed a fan switch! mine would kick in only after the car's temp hit bust....