i need help removing my core support is there any link or something that shows me how 2 remove it....or any that has done it b4 that can explain 2 me how 2 remove....
thanks.....
thanks.....
hey man, i've done this a few times..theres 2 ways i know of....depending on how badly damaged the radiator support is, sometimes you can get away with replacing only a section of it......there is spot welds all over to hold it together, also it has a very strong seam seal type adhesive on it...you might be able to cut the damaged section, go to the junkyard and get just that section, hold it in place, measure from the passenger rear bolt on the fender to the driver front on both sides, if you have the same measurements you should be ok...if its just a gap between your fender and hood, you can make the holes on the fender bigger so you have more play and can move it sideways more, or if you have to remove the entire radiator support you can drill out the spot welds and use an air hammer to separate the two pieces of metal, pretty easy that way, sometimes i just cut, and measure exactly how much, than i cut a good replacement from the junkyard, bolt it in place temporarily, make sure everything lines up and weld it in place...just a few ideas...hope this helps...peace