Search results

Have you checked the fluid level? Sent from my Nexus One using Tapatalk 2

No, shouldn't be any different. The ecu makes up the difference by keeping the iacv open longer. The actual iacv is the same Sent from my Nexus One using Tapatalk 2

Nice car. I've had two cb's and was a big contributor over at cb7Tuner.com. Reminds me of stickydiljoe's cb ,the first (and only?) Cb to make HondaTuner Tapatalk rocks!

^ ? I've never worked on that gen but i imagine you drain the oil, undo all the bolts around the outer edge and pull it off. Often times you have to remove the AT shift cover or the engine/tranny brace. Not a difficult procedure on any of the Hondas I've worked on Tapatalk rocks!

can you verify please your mechanical and electrical timing? make sure it hasn't jumped a tooth on the timing belt

I don't suggest using any additives. Tapatalk rocks!

Let me know if the z6 dizzy becomes available again! Tapatalk rocks!

You said your timing was 11°btc? Check what it's supposed to be, i think it's closer to 15 Tapatalk rocks!

Are you burning coolant? Do you get smoke out of the exhaust on startup? Tapatalk rocks!

O2 don't go cheap, use denso. A cheap one may ruin like s**t but not be defective. Same goes for spark plugs-ngk all the time Tapatalk rocks!

The place where i bought my engine operated out of new Jersey-is that too far? Tapatalk rocks!

Sounds like your wheel bearing is shot. I just had to replace mine and my buddies crx needs to be done Tapatalk rocks!

Also be sure to bleed your coolant to avoid air bubbles in your coolant which can cause idle issues. Tapatalk rocks!

Idle should be adjusted as such: start the engine and allow it to reach normal operating temperature. Jump the cel connector. Unplug the iacv plug. Adjust the idle to 650-700 using the idle adjust screw. Place some super glue or thread locker over the screw to keep it from vibrating out of...

Just because the fitv was cleaned doesn't mean anything. Remove the intake tube while the engine is warm and running. Check the bottom port on the tb. There should be little to no suction, and covering it should not affect the idle. If the fitv needs to be corrected, try screwing the beeswax...

Exhaust rattle can be loose heat Shields or a cat converter that's breaking up internally Tapatalk rocks!

Did you check FITV? Tapatalk rocks!

Have to say replace dizzy...what kind off symptoms are you having? Tapatalk rocks!

I would check the compression Tapatalk rocks!

I think he means the return line Tapatalk rocks!